Skip to content

Machinist Salary 2026 in Georgia

BLS estimates the median machinist wage in Georgia at $52,610 a year, about $25.29 an hour over a full-time year. BLS estimates 6,090 jobs in the state. The state median estimate is 10.5% below the national median of $58,750.

Estimated take home in Georgia, a year

$42,570

On the state median of $52,610, after federal tax, Social Security, Medicare and Georgia income tax. A single filer with a blank Form W-4: $1,637.31 a fortnight, an effective rate of 19.1%.

The spread in Georgia

BLS publishes selected percentile estimates for the state, not only the median. The take home column applies the current Georgia model to published numeric estimates; lower-bound rows stay uncalculated.

PercentileA yearEstimated take home
Lowest tenth$37,060$30,861
Lower quarter$43,480$35,689
Median$52,610$42,570
Upper quarter$64,180$51,301
Highest tenth$77,420$60,179

Georgia against the states next door

The wage estimates are BLS’s. Take home is modeled only where BLS publishes a numeric median estimate; # lower bounds remain labelled and uncalculated.

StateMedianEstimated take home
Georgia$52,610$42,570
Alabama$55,560$44,506
Florida$57,140$48,090
North Carolina$55,230$44,810
South Carolina$57,970$46,584
Tennessee$49,600$42,040

Relative to the state’s all-occupations estimate

BLS estimates the all-occupations median in Georgia at $48,170. The published machinist median estimate is 1.09times that benchmark; nationally the corresponding ratio is 1.15. This ratio is a wage comparison only and does not adjust for cost of living or individual experience.

Modeled gross pay for selected take home targets in Georgia

These are illustrative reverse calculations for a single filer using the deductions currently represented for Georgia. An actual payroll result may differ.

Target take homeEstimated gross needed
$50,000$62,450
$60,000$77,140
$75,000$100,100
$100,000$138,870

The same rate at different hours

BLS converts the annual estimate using a 2,080-hour year. This table shows illustrative weekly-hour scenarios using the same hourly estimate and theGeorgia deductions currently represented by the model.

Hours a weekGross a yearA fortnight
20$26,302$873.28
24$31,562$1,027.45
30$39,452$1,256.15
36$47,343$1,484.86
40$52,603$1,637.31
48$63,124$1,942.26

Put in your own hours

Seeded with the Georgia median. Change the hours, your Form W-4 answers or the state.

$an hour

Estimated average take home pay, biweekly

$1,637.31

$52,603.20 a year gross; the model estimates $42,570.27 after the deductions shown. That is 80.9% of gross under these assumptions.

Gross pay$2,023.20
Federal income tax- $158.94
Social Security- $125.44
Medicare- $29.34
Georgia income tax- $72.17
Take home$1,637.31

Worked out from: single filer · a blank Form W-4 · 40 hours a week · 0 GA allowances.

  • Georgia cut its flat rate to 4.99% and raised the single standard deduction to $15,000 for 2026. Figures quoted as 5.19% belong to the 2025 tax year.

About this calculator. It is general guidance, not a payslip. The figures are estimates based on selected 2026 federal and state publications and modeled assumptions. Sources, interpretations and code may be incomplete or wrong, and the result should not be relied on as an exact calculation of tax, payroll or anything else. Your employer knows things this page cannot: a mid-year rate change, a benefit deduction, a garnishment, a local tax, or what it has already withheld this year. Nothing here is tax, legal or financial advice, and using it creates no professional relationship. For anything that turns on the exact number, ask an accountant or a qualified adviser. Methodology and sources.

Pay history and 2026 trend estimate

Each numeric bar is the published Georgia median estimate for machinist in that year’s release. A BLS # lower bound or a year without an exact result is labelled instead of silently dropped. Bars run from zero. The 2021 method break is marked, and the earlier published bars remain visible as historical context without being joined to the post-change calculations. The separate 2026 figure is an HourlyPaycheck arithmetic extrapolation, not BLS data or a BLS forecast.

Published endpoint change
12.9%
From $46,600 in 2021 to $52,610 in 2025. The compound rate between those exact post-change endpoints is 3.1% a year; it is descriptive arithmetic, not a BLS time-series measure.
After inflation
−5.5%
Adjusting the two published endpoints with the selected inflation series gives a descriptive decrease from 2021 to 2025.
Illustrative 2026 trend estimateestimate
≈$54,200
This site carries the 3.1% compound annual change from 2021–2025 forward by one year. It is not a published BLS estimate or forecast.
  1. 2012$35,870
  2. 2013$34,640
  3. 2014$36,350
  4. 2015$37,120
  5. 2016$39,590
  6. 2017$41,230
  7. 2018$40,330
  8. 2019$40,970
  9. 2020$42,150
  10. 2021BLS changed its estimation method in May 2021; site calculations start here.
  11. 2021$46,600
  12. 2022$47,200
  13. 2023$48,520
  14. 2024$49,420
  15. 2025$52,610

BLS changed the OEWS estimation method beginning with the May 2021 estimates. Pre-2021 bars remain as raw published reference points; the wage, inflation, and employment calculations use post-change endpoints only. BLS also explains that the survey’s pooled design and changes in methods or classifications limit comparisons over time. The chart itself contains no future data point. The separate 2026 card is a rounded trend scenario calculated by this site and is not part of the measured series.

BLS estimated employment at 333,220 in 2021 and 287,050 in 2025, a modeled change of −13.9% between the two published estimates.

Questions people ask

What is the median machinist salary in Georgia?+

BLS estimates the median at $52,610 a year, about $25.29 an hour over a full-time year. The published mean estimate is $55,690. In the cited data, that median estimate is 10.5% below the national estimate of $58,750.

What is a machinist salary in Georgia after taxes?+

Using the state median estimate and the page's default filing assumptions, the model estimates $42,570 a year after federal income tax, Social Security, Medicare and Georgia income tax. The corresponding modeled biweekly amount is $1,637.31.

What is the salary range for a machinist in Georgia?+

The BLS lowest-tenth estimate is $37,060, and the highest-tenth estimate is $77,420. “At least” preserves the Bureau's # lower-bound marker; the figures are wage estimates rather than career stages.

Does a machinist earn more in Georgia or nearby?+

Against the states it borders, Georgia's median of $52,610 is below the highest neighboring median, South Carolina at $57,970. The table also shows modeled take home estimates under the same assumptions; it is not a comparison of actual payslips.

Machinist pay in other states

Or see machinist pay nationally and how Georgia taxes any wage.

Wages: BLS Occupational Employment and Wage Statistics, May 2025, SOC 51-4041. OEWS surveys wages in May and publishes about a year later, so this release appeared in May 2026 and is the most recent. Annual figures convert at 2,080 hours a year, as BLS states them. Tax is worked out here from the 2026 federal and Georgia tables.